www.fisher-price.comV7310Please keep this instruction sheet for future reference, as it contains important information. Requires three “AAA” (LR03) an
10Hint: We recommend using alkaline batteries for longer battery life.Battery InstallationLift the truck bed to access the battery compartment.• Loose
11• Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and f
12Color Control SteeringHints:We do not recommend using the vehicle outside in sand and grass. For best performance, • use on a hard, fl at surface ind
13Big Action™Drive the truck onto the elevator and watch it go up and down!• Drive the truck on to the the EZ Guide Ramps™•
14Big Action™Back the truck up to the boulder hopper to load boulders! • Grab boulders with the crane plunger! •
15TroubleshootingPROBLEM SOLUTIONTruck drives slowly Battery power in the truck may be weak. Replace all three batteries in the truck with new alkalin
16Slide the remote onto the tab by the crane for storage. • All other pieces easily store inside the playset! • StorageCareWipe this toy with a clean
Assembled PartsSupport Wall4 Supports(3 Gray and 1 Yellow)Tower TopBoulder HopperBoulder Crane2 Elevator RoofsTrackElevator CraneRampBase2 Elevator Fl
ICES-003 NMB-003This Class B digital apparatus complies with Canadian ICES-003.• Operation is subject to the following two conditions: (1) this dev
PRINTED IN MEXICO V7310pr-0920 Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.©2011 Mattel, Inc. All Rights Reserved.
53 Gray SupportsSupport WallTrackBaseAssemblyFit three the gray supports into the sockets in the bottom of the track. Push to • “snap” each in place.
6Yellow SupportGas PumpTower TopAssemblyTurn the assembly around so that the gas pump is facing you.• Fit the yellow support into the sockets in the b
7First, fi t the tabs on the top of the boulder hopper onto the grooves in the track • A.Next, fi t the hopper base into the slot in the ramp • B. Then,
8AssemblyFit two elevator walls into the slots in an elevator fl oor.• Hint: The elevator walls are designed to fit into the elevator floor one way. If
9AssemblyFit the pegs on the end of the elevator crane into the grooves in the other elevator. Push to • “snap” in place.Hint: The elevator is designe
Commentaires sur ces manuels