www.fisher-price.comPlease read these instructions before assembly and use of this product.Adult assembly is required.Tool needed for battery installa
Battery Safety InformationBatteries may leak fluids that can cause a chemical burninjury or ruin your product. To avoid battery leakage:• Do not mix o
11Set-Up & Use• Place your child in the seat. Position the crotch belt betweenyour child’s legs.• Fasten the waist belts to the crotch belt. Make
12Set-Up & UsePower DialPower DialStarting the Swing• Turn the power dial to any of eight settings.• Give the seat a light push to start the swing
Baby Activated13Set-Up & UseHint: Your baby can enjoy lights and music with or without swinging.Parent Activated• Slide the lights and music switc
14• Fit the link toys to either of the hanging toys on the swing.Room-to-Room PortabilitySet-Up & Use• To prevent serious injury or deathfrom fall
15Take Along• Lift the seat back and seat bottom together.• Tip the swing backwards with the seat back down.• Press both tabs on the frame at the same
Care• The frame, pad, liner and toys may be wiped clean using amild cleaning solution and a damp cloth. Do not immerse the frame.• This product has no
2To prevent serious injury or deathfrom falls and being strangled inthe restraint system:- Always use the restraint system.- Not recommended for child
3Parts3 Link ToysSeat Back TubePad Front TubeLower Swing Arm Assembly (with Restraint System)Frame2 Frame TubesShown Actual Size#6 x 1.9 cm Screws - 4
4Assembly• Rotate the upper frame tube until it "snaps" into an uprightposition, as shown.IMPORTANT! Before assembly, inspect this product f
5Assembly• Pull the front tube to be sure it is secure to each lower frame tube.• While pressing the buttons on the upper frame tubes,insert them into
6Assembly• Check to be sure the upper frame tubes are secure in theframe. If you can remove the upper frame tubes from theframe, you have not properly
7Assembly• Position the seat back tube so that it curves toward the backof the swing.• While pressing the buttons on the seat back tube, fit theseat b
108Assembly• From behind the seat, insert the waist belts into the slots inthe pad.• Push to fasten the restraint system to the pad.Assembly is now co
9Battery Installation1.5V x 4LR14 SHOWN ACTUAL SIZEHint: We recommend using alkalinebatteries for longer battery life.• Locate the battery compartment
Commentaires sur ces manuels